PassLeader released the NEWEST CompTIA N10-006 exam dumps recently! Both N10-006 VCE dumps and N10-006 PDF dumps are available on PassLeader, either N10-006 VCE dumps or N10-006 PDF dumps have the NEWEST N10-006 exam questions in it, they will help you passing CompTIA N10-006 exam easily! You can download the valid N10-006 dumps VCE and PDF from PassLeader here: https://www.passleader.com/n10-006.html (1521 Q&As Dumps –> 1643 Q&As Dumps)
Also, previewing the NEWEST PassLeader N10-006 dumps online for free on Google Drive: https://drive.google.com/open?id=0B-ob6L_QjGLpSDB2amRraUV5OVk
QUESTION 1381
A technician is being tasked to centralize the management of the switches and segment the switches by broadcast domains. The company is currently all on VLAN1 using a single private IP address range with a 24 bit mask. The supervisor wants VLAN 100 to be the management subnet and all switches to share the VLAN information. Which of the following options would work BEST to accomplish these requirements?
A.   Use VLSM on the IP address range, with STP and 802.1q on the inter switch connections with native VLAN 100
B.   Use VLSM on the IP address range with VTP and 802.1x on all inter switch connections with native VLAN 100
C.   Use VLSM on VLAN1, with VTP and 802.1w on the inter switch connections with native VLAN 100
D.   Use VLSM on the IP address range with VTP and 802.1q on the inter switch connections with native VLAN 100
Answer: D
QUESTION 1382
A new network administrator is hired to replace a consultant that has been keeping the network running for several months. After a month, the network administrator is having network issues. The problems are easily resolved and appear to be changes in the server settings. The log files on the servers do not contain any error or messages related to the issues. Which of the following is a possible cause of the issues?
A.   TACAS\Radius misconfiguration is causing logs to be erased.
B.   ICMP ping of death is resetting DHCP and DNS on the server.
C.   A backdoor has been installed to access the network.
D.   The last ACL on the router is set to Deny All.
Answer: C
QUESTION 1383
A network administrator set up a network computer lab and discovered connectivity issues. The administrator is able to ping the fiber uplink interface, but none of the new PCs plugged into the switch respond to ICMP requests. Which of the following should the administrator perform FIRST?
A.   Check if there are link lights on the ports.
B.   Check the ports on the switch for full duplex.
C.   Check to see if port security is enabled.
D.   Check to see if the uplink interface is configured correctly.
Answer: A
QUESTION 1384
A user receives a new computer and now is unable to connect to a database using ODBC. Other users on the network are able to connect successfully. A technician is able to successfully ping the database server but still is unable to connect. Which of the following is the issue?
A.   Missing IP routes on router
B.   Wrong default gateway address
C.   Software firewall is blocking ports
D.   Failing network interface card
Answer: C
QUESTION 1385
A network uses a centralized server to manage credentials for all network devices. Which of the following server types are MOST likely being used in this configuration? (Select TWO.)
A.   DNS
B.   DHCP
C.   FTP
D.   RADIUS
E.   Kerberos
F.   TACACS
G.   Wireless controller
Answer: DF
QUESTION 1386
A company suffers an outage due to a bad module in a core switch. Which of the following is the proper order of troubleshooting?
A.   Gather information, start at the top of the OSI model, and work down.
B.   Establish a plan of action to solve the problem.
C.   Establish a theory, identify the problem, duplicate the problem, test the theory, and repeat.
D.   Gather information, start at the bottom of the OSI model, and work up.
Answer: B
QUESTION 1387
Which of the following is BEST used to perform a one-time temporary posture assessment in a NAC environment?
A.   Intrusion prevention system
B.   Host-based firewall
C.   Non-persistent agent
D.   Antivirus
Answer: C
QUESTION 1388
A network technician has just run a new point-to point fiber link between two local routers, however, after the fiber has been plugged in on both ends, the interface will not come up. The technician has double-checked the interface configuration on both routers, both SFPs have been hard looped to confirm they are functioning, connectors on both ends of the links have been cleaned, and there is sufficient optical power. Which of the following is the cause of the issue?
A.   Wavelength mismatch
B.   Duplex mismatch
C.   Distance limitations
D.   Wrong IP address
Answer: A
QUESTION 1389
Two switches are connected using both a CAT6 cable and a CAT5e cable. Which of the following problems is occurring?
A.   Missing route
B.   Autosensing ports
C.   Improper cable types
D.   Switching loop
E.   Media mismatch
Answer: D
QUESTION 1390
A network administrator has configured a new 100Mbs WAN circuit, but speed testing shows poor performance when downloading large files. The download initially reaches close to 100Mbps but begins to drop and show spikes in the downloads speeds over time. The administrator checks the router interface and sees the following:
– Router01#show interface eth 1/1
– GigabitEthernet 1/1 is up, line is up
– Hardware is GigabitEthernet, address is 000A.00BB.CC11
– Configured speed auto, actual 1Gbit, configured duplex fdx, actual fdx Member of L2 VLAN 1, port is untagged, port state is forwarding
Which of the following is MOST likely to resolve the issue?
A.   Shutdown and then re-enable this interface
B.   Reset the statistics counter for this interface
C.   Remove default 802.1q tag and set to server VLAN
D.   Apply egress port rate-shaping
Answer: C
QUESTION 1391
Which of the following residential Internet medias would employ the DOCSIS standard?
A.   Fiber
B.   DSL
C.   Cable
D.   3G/LTE
E.   Cellular
Answer: C
QUESTION 1392
Joe, a technician, terminates ends on a new copper cable for use between two legacy switches. When Joe connects the two switches together using the cable, they fail to establish a connection. Which of the following is MOST likely the issue?
A.   The cable has exceeded bend radius limitations.
B.   The cable is a straight through.
C.   The cableis a cross over.
D.   The cable has RJ-11 connectors instead of RJ-45.
Answer: B
QUESTION 1393
A network technician has set up a firewall and entered only three rules allowing traffic on ports 21, 110, and 25 to secure the network. Users are reporting they cannot access web pages using the URLs. Which of the following can the technician do to correct the situation?
A.   Add a rule to the end allowing port 80 and 53.
B.   Add a rule to the end allowing port 143 and 22.
C.   Add a rule to the end allowing port 137 and 66.
D.   Add a rule to the end allowing port 445 and 173.
Answer: A
QUESTION 1394
A secondary datacenter in a remote location is used by a company. The cable management and power management are handled by the datacenter staff. The building security is also handled by the datacenter staff with little oversight. Which of the following should the network administrator do to adhere to best practices?
A.   Secure the patch panels.
B.   Ensure power monitoring is enabled.
C.   Ensure rack security.
D.   Secure the UPS units.
Answer: C
QUESTION 1395
When network administrators observe an increased amount of web traffic without an increased number of financial transactions, the company is MOST likely experiencing which of the following attacks?
A.   Bluejacking
B.   ARP cache poisoning
C.   Phishing
D.   DoS
Answer: D
QUESTION 1396
An administrator needs to install a centrally located firewall that needs to block specific incoming and outgoing IP addresses, without denying legitimate return traffic. Which of the following firewall types should the administrator install?
A.   A host-based firewall
B.   A network-based firewall
C.   A host-based stateful firewall
D.   A stateless network-based firewall
Answer: D
QUESTION 1397
All scheduled work on production network equipment should be done during which of the following periods?
A.   Maintenance window
B.   Development life cycle
C.   Down time
D.   Business hours
Answer: A
QUESTION 1398
A technician is installing a media converter that connects a newly installed multimode connection to an existing CAT5e infrastructure. Which of the following media converter types should the technician use?
A.   Ethernet to coaxial
B.   Fiber to Ethernet
C.   Fiber to coaxial
D.   Multimode to single mode fiber
Answer: B
QUESTION 1399
Ann, a network administrator, is in the process of cleaning network switches for resale. Ann splashes the cleaning agent in her eye and needs to know the procedure of cleansing her eye. To which of the following should Ann refer?
A.   EULA
B.   MSDS
C.   SLA
D.   MOU
Answer: B
QUESTION 1400
Which of the following transmission methods is used for network utilizing the 802.3 standard?
A.   MAC
B.   Synchronous
C.   DSSS
D.   Broadband
E.   Baseband
Answer: A
Welcome to choose PassLeader N10-006 dumps for 100% passing CompTIA N10-006 exam: https://www.passleader.com/n10-006.html (1521 Q&As VCE Dumps and PDF Dumps –> 1643 Q&As VCE Dumps and PDF Dumps)
Also, previewing the NEWEST PassLeader N10-006 dumps online for free on Google Drive: https://drive.google.com/open?id=0B-ob6L_QjGLpSDB2amRraUV5OVk