PassLeader released the NEWEST CompTIA 220-1101 exam dumps recently! Both 220-1101 VCE dumps and 220-1101 PDF dumps are available on PassLeader, either 220-1101 VCE dumps or 220-1101 PDF dumps have the NEWEST 220-1101 exam questions in it, they will help you passing CompTIA 220-1101 exam easily! You can download the valid 220-1101 dumps VCE and PDF from PassLeader here:Â https://www.passleader.com/220-1101.html (502 Q&As Dumps –> 845 Q&As Dumps ~ Lab Simulations Available)
Also, previewing the NEWEST PassLeader 220-1101 dumps online for free on Google Drive: https://drive.google.com/drive/folders/14J4GQ6iYbG9EPexqPtyTo7YzchW9C2dZ
NEW QUESTION 461
In a SOHO environment, a user wants to make sensitive scanned documents available to other users on the domain. The logs need to indicate who accessed the documents and at what time they were accessed. Which of the following settings should a technician set up on the MFP device?
A.   Scan to email.
B.   ADF tray.
C.   PCL.
D.   SMB share.
Answer: D
NEW QUESTION 462
A user reports that a display is slow to turn on, and the colors are distorted and discolored. Once the display turns on, it appears to have lines going through the image and intermittently goes blank. Which of the following is the most likely cause of the issue?
A.   Incorrect data source.
B.   Incorrect resolution settings.
C.   Physical cabling issues.
D.   Incorrect refresh rate.
E.   Display burn-in.
Answer: C
Explanation:
Physical cabling issues can lead to problems like distorted colors, lines on the screen, intermittent blanking, and slow display turn-on. Loose or damaged cables, connectors, or pins can result in data transmission problems between the computer and the monitor.
NEW QUESTION 463
Which of the following wireless technologies would a company most likely implement for inventory management?
A.   NFC
B.   5G
C.   Bluetooth
D.   RFID
Answer: D
NEW QUESTION 464
A systems administrator hears a clicking noise coming from a storage array that has a RAID configuration. No LEDs are illuminated on the array, but the logs show several hard drive errors. Which of the following should the systems administrator do to quickly eliminate the clicking?
A.   Reinstall the drive.
B.   Replace the bad drive.
C.   Reset the RAID software.
D.   Run a chkdsk on the drive.
Answer: B
NEW QUESTION 465
A technician installed a Cat 5 UTP cable approximately 275ft (84m) from a network switch in an office to a workstation located on a factory floor. The technician sees both a flashing green LED and a flashing orange LED on the workstation’s NIC. Which of the following should the technician do FIRST?
A.   Check for loose connections, pinched bends, and physical damage.
B.   Install a powered hub as close as possible to the halfway point in the Cat 5 UTP cable run.
C.   Replace the entire run of Cat 5 UTP cable with Cat 5 STP cable.
D.   Upgrade the entire cable run to multimode fiber.
Answer: A
NEW QUESTION 466
A regularly used laser printer is printing vertical lines on each page. Which of the following should the technician do first?
A.   Lower the printing contrast.
B.   Change the paper type.
C.   Install a new fuser.
D.   Replace the toner cartridge.
Answer: D
NEW QUESTION 467
A technician is installing the RAM for a graphics workstation. Which of the following is special purpose memory used by graphic controllers?
A.   SRAM
B.   MicroDIMM
C.   VRAM
D.   Unbuffered DIMM
Answer: C
NEW QUESTION 468
A technician recently installed a new printer that is being shared over the network via a 64-bit Windows Print Server. Two users, who have computers with a legacy OS, are unable to print to this new printer. Which of the following should the technician do to resolve this issue?
A.   Enable 32-bit drivers on the Print Server.
B.   Enable Print Spooler and restart the computer.
C.   Run Windows Update on the users’ computers.
D.   Update the computers to a 64-bit driver.
Answer: A
NEW QUESTION 469
A user needs a technician’s help connecting a laptop to a projector. The projector is old and only has analog input. Which of the following cable types should the technician use to connect the laptop to the projector?
A.   HDMI
B.   RS-232
C.   VGA
D.   DisplayPort
Answer: C
NEW QUESTION 470
Which of the following solutions can help users who have the current Windows operating systems run legacy applications that are not supported under the latest applications?
A.   AppLocker.
B.   Type 1 hypervisors.
C.   Sandbox.
D.   Application virtualization.
Answer: D
NEW QUESTION 471
A technician is replacing a failed drive in a RAID 5 array. Which of the following is the first step the technician should take before hot swapping the drive out of the array?
A.   Document the replacement date.
B.   Shut down the array.
C.   Safely dispose of the failed drive.
D.   Perform a full backup.
Answer: A
Explanation:
First step to consider is to document the replacement date to keep record of when the drive was replaced, then other steps can follow. Documenting a replacement date helps with tracking changes, future troubleshooting and maintenance, which aids in RAID array management.
NEW QUESTION 472
An administrator notices that on an intermittent basis the virtual machines are running slowly. The virtual machines are correctly sized, and the hardware has enough free resources to cope with demand. Which of the following is most likely the cause?
A.   The physical servers are not able to draw enough power.
B.   The physical servers do not have enough network bandwidth.
C.   The physical servers are throttling due to overheating.
D.   The physical servers are contending for resources.
Answer: C
NEW QUESTION 473
Which of the following technologies can be used to harden guest virtual machines?
A.   Containerization.
B.   Network isolation.
C.   Resource reservation.
D.   vTPM.
Answer: D
NEW QUESTION 474
A technician is attempting to connect the wired LANs at two nearby buildings by installing a wireless point-to-point connection. Which of the following should the technician consider?
A.   NFC protocol data rate.
B.   RFID frequency range.
C.   Bluetooth version compatibility.
D.   Allowable limits for transmit power.
Answer: D
NEW QUESTION 475
Which of the following network devices should a technician install in order to isolate voice traffic on the network?
A.   Network tap.
B.   Managed switch.
C.   Hub.
D.   DSL filter.
Answer: B
NEW QUESTION 476
An analyst has replaced the motherboard in a desktop computer that previously overheated. The analyst presses the power button, hears three beeps, and sees the screen is black. Which of the following is the best action for the analyst to take to fix this issue?
A.   Replace the power supply.
B.   Reseat the RAM.
C.   Reattach the hard drive.
D.   Flash the BIOS.
Answer: B
NEW QUESTION 477
A technician is troubleshooting a network issue and needs to check the status of a local network device in the least disruptive manner possible. Which of the following tools should the technician use to accomplish this task?
A.   Network tap.
B.   Cable tester.
C.   Multimeter.
D.   Tone generator.
Answer: B
NEW QUESTION 478
A technician is working to replace a single DDR3 RAM module on a laptop that has two occupied slots. When the technician tries to turn on the laptop, the computer starts beeping and does not pass POST. The technician double-checks the newly installed RAM and notices a motherboard message indicating low voltage. Which of the following is the most likely cause of this issue?
A.   Faulty power adapter.
B.   Incorrect BIOS settings.
C.   Failing CMOS battery.
D.   Unsupported memory.
Answer: D
NEW QUESTION 479
A printer displays an error message even after a paper jam is cleared. Which of the following should a technician do to fix the issue?
A.   Check the paper path for a blocked sensor.
B.   Verify the pickup roller is functioning.
C.   Change the duplex settings.
D.   Run internal printer diagnostics.
Answer: A
NEW QUESTION 480
Which of the following explains how using a cloud infrastructure can provide rapid elasticity?
A.   Shared resources can reduce overhead.
B.   Customers can limit the use of a resource.
C.   High availability of services can be provided.
D.   Systems can be provisioned according to demand.
Answer: D
NEW QUESTION 481
A technician is trying to fix a computer that fails to boot even when all the RAM is removed. Which of the following should the technician do next to troubleshoot the issue?
A.   Inspect the motherboard for swollen capacitors.
B.   Replace the CMOS battery.
C.   Swap the power supply if it is inoperable.
D.   Check to see if the HDD power connectors are well seated.
Answer: A
NEW QUESTION 482
A new VoIP solution is being implemented at a corporate office for more than 200 users. The new VoIP devices do not require AC adapters at the users’ desks. Which of the following network devices should a technician purchase?
A.   Firewall.
B.   Power injector.
C.   PoE switch.
D.   Router.
Answer: C
NEW QUESTION 483
A technician received a help desk ticket from a user who is unable to browse the internet. Which of the following troubleshooting steps should the technician perform first?
A.   Establish a plan of action.
B.   Document the findings.
C.   Test the theory.
D.   Identify the problem.
Answer: D
NEW QUESTION 484
A graphic designer wants to purchase a laptop that provides the most accurate color spectrum available when viewed from as many different angles as possible. Which is the following display types would best meet the graphic designer’s requirements?
A.   LCD
B.   Plasma
C.   OLED
D.   VGA
Answer: C
NEW QUESTION 485
Which of the following are benefits of application virtualization? (Choose two.)
A.   The network works more quickly.
B.   Applications are easier to learn.
C.   RAM works more efficiently.
D.   The overall IT cost goes down.
E.   OS performance is superior.
F.   Upgrading applications is easier.
Answer: DF
NEW QUESTION 486
A technician is creating a new RAID array for a customer. After interviewing the customer, the technician decides to implement a RAID array of striping without parity. Which of the following reasons would lead the technician to choose striping without parity instead of striping with parity?
A.   Uptime is the customer’s biggest concern.
B.   Speed is the most important consideration.
C.   Redundancy and speed are equally important.
D.   Available storage space needs to be maximized.
Answer: B
NEW QUESTION 487
A classroom projector, which is turned on, displays a flashing LED code but does not have any video output. Which of the following should a technician do to resolve the issue?
A.   Replace the bulb.
B.   Adjust the input resolution.
C.   Clean the air filter.
D.   Change the input source.
Answer: A
NEW QUESTION 488
A laptop’s external webcam software is running, but neither images nor videos can be viewed. Which of the following should a technician do first?
A.   Reseat the webcam.
B.   Restart the computer and run system diagnostics.
C.   Reinstall the webcam software and drivers.
D.   Research new webcam firmware.
Answer: A
NEW QUESTION 489
A technician is creating a consecutive range of IP addresses that a server can select from to fulfill requests from network clients. Which of the following is the technician creating?
A.   DHCP scope.
B.   Static IP list.
C.   DNS A records.
D.   Automatic private IP addressing.
Answer: A
NEW QUESTION 490
Every time a user tries to print a multipage document, the user is unable to print on both sides of the page. Which of the following settings will most likely resolve this issue?
A.   Orientation.
B.   Duplex.
C.   Quality.
D.   Print tray.
Answer: B
NEW QUESTION 491
……
Welcome to choose PassLeader 220-1101 dumps for 100% passing CompTIA 220-1101 exam:Â https://www.passleader.com/220-1101.html (502 Q&As VCE Dumps and PDF Dumps –> 845 Q&As VCE Dumps and PDF Dumps ~ Lab Simulations Available)
Also, previewing the NEWEST PassLeader 220-1101 dumps online for free on Google Drive: https://drive.google.com/drive/folders/14J4GQ6iYbG9EPexqPtyTo7YzchW9C2dZ